User manual ROSE DISPLAYS QUICKGRIP WITH PEGS AND MULTICLIPS

[. . . ] QuickGripTM with Peg Parts Instruction Sheet 2 QuickGrip 12-0500 2 Multiclips 1UP-0101 4 End Caps 06-5525 2 Pegs 06-1920 Instructions for Hanging Step 1 When using QuickGrip to hang 1/8" Sintra or an equally heavy substrate, have your printer punch two 1/4" holes along the top and bottom edges of print -- or only the top if no bottom holder is being used. [. . . ] 5 Repeat step 3 for second MultiClip. Figure 5 Step 5 Push end caps into place. Neither the manufacturer nor any sales agent may be held liable for injury, loss or damage resulting from the use of these products. Part #03INSQuickGripPegMC Figure 6 Figure 7 Incept-3. 11. 03 35 Congress Street, Salem, MA 01945 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com QuickGripTM with Peg Parts Instruction Sheet 2 QuickGrip 12-0500 2 Multiclips 1UP-0101 4 End Caps 06-5525 2 Pegs 06-1920 Instructions for Hanging Step 1 When using QuickGrip to hang 1/8" Sintra or an equally heavy substrate, have your printer punch two 1/4" holes along the top and bottom edges of print -- or only the top if no bottom holder is being used. 1 Note: Each hole must be centered 1/4" in from the edge of the substrate. Figure 1 Figure 2 Figure 3 Step 2 Push both parts of the peg together through each of the punched holes. 3 Note: This is the easiest way to safely hang heavier substrates. Figure 4 Step 4 Squeeze sides of MultiClip together. 4 Align the bottom rail of the MultiClip with the top channel of the plastic holder. [. . . ] Part #03INSQuickGripPegMC Figure 6 Figure 7 Incept-3. 11. 03 35 Congress Street, Salem, MA 01945 Tel# 1-800-631-9707 Fax# 1-800-560-2890 e-mail:signware@rosedisplays. com [. . . ]