User manual SCOTSMAN CME456R

[. . . ] When a user pushes the dispense button a rotating wheel scoops the ice up to the top front of the hopper where there is an outlet to the ice chute. Table of Contents Specifications/Limitations . page 7 Final Check List/Initial Start Up/Electrical Sequence Cleaning . page 10 Parts lists and wiring diagrams are located in the center of this manual, printed on yellow paper. [. . . ] Remove the screws that hold the push button switch to the dispenser and remove the push button switch. Remove cover plate on right side of front panel, below push button switch; use 5/16" nut driver. Secure the coin mechanism to the mounting plate from the inside of the dispenser. Remove the timer mechanism from the kit and install it in the control box. Remove wires numbered 8 and 9 from the control box, they will be replaced by new wires from the kit marked 8 and 9. After everything is operating, give key to user. Control Box Layout Control Relay Coin Mech Relay Electrical Shock Hazard. Disconnect electrical power before beginning procedures. Adjustment Coin Mech Timer Agitation Timer Electrical Sequence 1. Timer closes internal contacts, connecting power to gearmotor (and door solenoid if -1B) 3. Gearmotor rotates dispense wheel until internal timer contacts (AND cam switch contacts if -1) open. The time of rotation (and amount of ice dispensed) is determined by the timer. May 2000 Page 5 HD150 Key Kit Installation: (KSLDK2) 1. Place switch mounting bracket behind cover plate and over fitting, with the switch below the fitting. Using the locknut provided, fasten the fitting in place with the flats vertical. Place the cylinder in the brass fitting, and secure to the fitting with the set screw. Push hotel/motel key into the cylinder and adjust lever of micro switch so the switch closes when the key is pushed all the way in. [. . . ] Using the ice machine cleaning solution, clean the ice grill, sink, and water pan. A possible sanitizer: Mix a solution of ice machine sanitizer and water: 1 ounce of household bleach to 2 gallons of (95oF. -1150F. ) water. Reach into the opening, locate the large nut securing the wheel to the drive shaft. [. . . ]