User manual SCOTSMAN HD30 INSTALL GUIDE

[. . . ] Tokens are available from Scotsman, the part number for 500 tokens is KTOKEN. Water station models are basic models with a separate non-refrigerated water dispense station. September 2003 Page 2 HD22 and HD30 Specifications & Limitations This dispenser is designed to be installed and operated indoors, in a controlled environment. Its minimum and maximum operating temperature limits are the same as those for the ice machine. Minimum Air Temp Voltage 60 Hz 50 F 104 o Kits: A bin top adapter kit is also available to allow placement of a Scotsman CME686 or CME810 Eclipse ice making head on the dispenser. [. . . ] User Pan debris is kept away from the drain in the catch pan by a slotted shield. Coin / Token Model The coin op model's operation is identical to the basic operation described above with the exception that no power is provided to the vend switch until the coin mechanism has activated the vend timer. The vend timer then allows the vend switch to be activated for a set time, during that time the user must dispense the ice. A green "ready" light over the vending area will glow when the vend timer is armed and ready for dispensing. Bin Sweep Arm Dispense Wheel Drain Hose to Ice Catch Pan Drain Hose September 2003 Page 6 HD22 and HD30 Unpacking After removing the carton, check for the loose-shipped parts packed in the storage bin. To remove the skid, place part of the carton behind the unit and tip the unit on its back. Remove the bolts holding the skid to the base of the HD dispenser and separate the skid from the unit. Install the legs into the base of the unit, using the holes where the skid bolts were. Turn the leg leveler part of the legs in all the way, adjust them later after the unit is in its final installed position. Move the dispenser to an upright position and set it in the location where it will be installed. Top Panel Front Panel Removal The front panel rests on the base and is located with pins that stick up from the base. Pull the top edge of the front panel forward until the two snaps disengage. ·If the unit is a coin op model, reach behind the front panel and disconnect the coin mechanism harness from the front panel. the front panel and shut off the water supply valve to the water faucet. Front Panel ·If the unit is a water station model, reach behind September 2003 Page 7 HD22 and HD30 Installation - Plumbing Drain: All models of the dispenser have a 3/4" FPT drain fitting at the bottom of the back panel. Connect 3/4" rigid tubing to this connection, a vent is recommended for most installations. If using copper, sweat the copper tube to copper fitting together before installing on the dispenser. Because the drain tubing will be very cold, insulation is recommenced for the tubing. Water: HD30 water station models must be connected to a source of potable water. The water supply must have adequate backflow protection to comply with applicable codes. Flush the water supply line before connecting it to the dispenser. Drain Connection, Back View of Dispenser September 2003 Page 8 HD22 and HD30 Installation - Electrical and Ice Machine Assembly The dispenser is supplied with a power cord. The gearmotor will have power and the dispenser will continue to operate as long as the ice chute is pushed in. Since the ice chute is not pushed in during agitation no ice is dispensed. September 2003 Page 10 HD22 and HD30 Use Basic Model After the ice machine has operated for a few hours, the HD dispenser can be used. [. . . ] Slide the ice catch pan out of the ice dispenser and clear it of any debris. Screen Ice Catch Pan September 2003 Page 14 HD22 and HD30 Adjustments The dispenser is preset at the factory. Agitation Time Recommendations: The standard time is 3 seconds on every 6 hours. Adjust to agitate more frequently if the unit is installed in a low temperature environment. [. . . ]