User manual SCOTSMAN ID150

[. . . ] Scotsman reserves the right to make design changes and/or improvements at any time. Specifications and designs are subject to change without notice. Model Dimensions w" x d" x h" Basic Electrical 115/60/1 115/60/1 115/60/1 Hopper Capacity 150 lb 200 lb 250 lb Amps Cup Clearance 10" 10" 10" Dispense Actuation Method Lever Lever Lever ID150B-1A 22 x 30 x 35 5/8 ID200B-1A 30 x 30 x 35 5/8 ID250B-1A 30 x 30 x 39 5/8 3. 0 3. 5 3. 5 Note: Dispenser height includes cover (1 5/8"). Diverter kit for Scotsman Nugget Ice (KNUGDIV) Adapters: Adapters are required for placing an ice machine onto the top of this dispenser. [. . . ] Connect field water supply to ¼ male flare fitting on tubing assembly. Check that tubing assembly does not interfere with wiring or electrical components. Carefully reinstall panels on unit. May 2002 Page 5 ID150, ID200, ID250 WATER GLASS KIT - CONTINUED ID150 A B 4" 2. 5" ID200, ID250 A B 6 1/8" 3 1/8" Water inlet can be routed either from the back or from underneath the dispenser. A hole is not needed at the intersection of C and D, unless the back access panel is retained. May 2002 Page 6 ID150, ID200, ID250 ICE DIVERTER KIT NOTE: For dispensing Scotsman Nugget Ice: 1. Apply RTV to back surface of ice diverter, to seal to gate mounting plate. Note: The agitation timer must be adjusted to the MINIMUM position when dispensing nugget ice. Check the label in the electrical box to confirm these procedures: ·Rotate the Motor On Time adjustment fully CCW to get the half second setting. get the 3 hour setting. ·Rotate the Off Time adjustment fully CW to May 2002 Page 7 ID150, ID200, ID250 INITIAL START UP 1. Plug the unit's power cord into an electrical outlet and the lighted sign should come on. In normal operation, pushing the ice dispenser mechanism will cause ice to flow from the ice chute. Clean up immediately any spilled ice from filling or operating the unit. To prevent contamination of ice, the lid must be installed on the unit at all times. If the dispenser fails to dispense ice or beverage see troubleshooting guide. May 2002 Page 8 ID150, ID200, ID250 GATE RESTRICTOR PLATE CAUTION: Disconnect power to dispenser before installing, removing or adjusting restrictor. ADJUSTMENT This plate may be adjusted as shown to reduce or increase the dispensing rate of ice, especially desirable when using glasses or other containers with small openings. Adjustment can be made by sliding up or down with nuts loosened, to obtain the desired amount of restriction. May 2002 Page 9 ID150, ID200, ID250 CLEANING AND SANITIZING The sink, grill and splash panel area should be cleaned daily. [. . . ] Wipe the top edge of the ice hopper with the sanitizing solution, allow to air dry. Plug the unit in, and it is now ready to dispense ice. ID150, ID200, ID250 TROUBLESHOOTING IMPORTANT: Only qualified personnel should service internal components or electrical wiring. Should your unit fail to operate properly, check that there is power to the unit and that the hopper contains ice. [. . . ]