User manual SCOTSMAN IS150

[. . . ] Scotsman assumes no liability or responsibility of any kind for products manufactured by Scotsman that have been altered in any way, including the use of any parts and/or other components not specifically approved by Scotsman. Scotsman reserves the right to make design changes and/or improvements at any time. Specifications and designs are subject to change without notice. October 1993 Page 2 IS100 and IS150 DISPENSER MODEL IDENTIFICATION The complete model number of the dispenser describes many of its options: IS Type 100 Bin Capacity E -L Cabinet Activation Finish Method F Display Type -1 Voltage A Series In this example, the IS100E-LF-1A is an Ice Station with 100 lb. [. . . ] Agitation of the ice keeps it from fusing together after long periods in the bin. Ice hopper contains parts that can move at any time, and will cause injury if hands are in the way. Do not remove cover until the unit has been unplugged from the electrical power. Plug the unit's power cord into an electrical outlet, if the unit has a lighted sign, it should come on. Dispense several containers of ice. FOR THE OPERATOR This section covers operating controls, daily pre-operation check, and unit operation. Lever: Ice will continue to be dispensed for as long as the lever is held in, or until the hopper is empty. Push Button: When the ice dispense button is pushed, ice will be dispensed for as long as the button is held in or until the hopper is empty. The ice must be broken up in the bags first before adding to the hopper. Large chunks of ice can NOT be dispensed. HOT WATER The dispenser must always contain ice to have ice available for use. Keep the cover in place, and check the ice supply regularly during operating hours. At the end of the day: Remove the grill from the sink, clean the sink, grill and splash panel, make sure the sink drain is open by pouring hot water into the sink. Return the grill to the sink. October 1993 Page 5 IS100 and IS150 HOW IT WORKS The ice is stored in a hopper, and the hopper is sloped towards the front. At the front there is an angled rotor: when that rotor turns, it scoops the ice, lifts it to the top of the ice chute and drops it through that chute into the user's container. CUT AWAY VIEW ICE ROTOR DOOR UPPER ICE CHUTE ICE CHUTE October 1993 Page 6 IS100 and IS150 CLEANING AND SANITIZING The sink, grill and splash panel area should be cleaned daily. Use soap, hot water, and a clean cloth to wash sink and splash panel; rinse with hot water, allowing plenty of hot water to run down the drain. Rinse out the sponge with clean water, wring excess water out of the sponge, and wipe off external surfaces of the unit. [. . . ] Wipe all surfaces of the rotor (plus ice chute, shield and bearing if used) with the sanitizing solution, and allow to air dry. Pull out and remove the upper front panel. IS100 and IS150 SERVICE DIAGNOSIS PROBLEM Will not dispense ice PROBABLE CAUSE 1. Check relays, replace if necessary. ELECTRICAL SEQUENCE Refer to the wiring diagram. [. . . ]