User manual SCOTSMAN IS220

[. . . ] Attach the upper front cover by pushing the strikes on the cover into the catches on the unit. * Optional depending upon unit configuration. SPLASH PANEL MOUNTING TABS 4. [. . . ] Push Button: When the ice dispense button is pushed, ice will be dispensed for as long as the button is held in or until the hopper is empty. The ice must be broken up in the bags first before adding to the hopper. Keep the cover in place, and check the ice supply regularly during operating hours. At the end of the day: Remove the grill from the sink, clean the sink, grill and splash panel, make sure the sink drain is open by pouring hot water into the sink. Return the grill to the sink. HOT WATER August 1995 Page 7 IS160 and IS220 HOW IT WORKS The ice is stored in a hopper. At the front of the hopper there is an angled rotor: when that rotor turns, it scoops the ice, lifts it to the top of the ice chute and drops it through that chute into the user's container. CUT AWAY VIEW ICE Note: Ice On The Bottom of The Hopper Will Not Be Dispensed. ROTOR DOOR UPPER ICE CHUTE ICE CHUTE August 1995 Page 8 IS160 and IS220 CLEANING AND SANITIZING The sink, grill and splash panel area should be cleaned daily. Use soap, hot water, and a clean cloth to wash sink and splash panel; rinse with hot water, allowing plenty of hot water to run down the drain. Rinse out the sponge with clean water, wring excess water out of the sponge, and wipe off external surfaces of the unit. Do NOT use abrasive type cleaners. POUR HOT WATER DOWN SINK TO CLEAN OUT DRAIN. August 1995 Page 9 IS160 and IS220 CLEANING AND SANITIZING MONTHLY & INITIAL START UP: Sanitize the Ice Storage System. Unplug the Ice Stand's electrical cord from the electrical power. Locate the two thumb screws holding the upper ice chute; remove them (1 on top and 1 below). Thoroughly wipe the surfaces of the bin door and both ice chutes with the sanitizing solution, and allow to air dry. Place the upper ice chute back onto the dispenser, secure with the three thumb screws. UPPER ICE CHUTE Ice hopper contains parts that can move at any time, and will cause injury if hands are in the way. [. . . ] · When relay A's contacts 7-4 close, they make a circuit to the coil of relay B. · When relay A's contacts 7-1 open, the circuit to the timer is opened. [. . . ]