User manual SENSEO HD7803

[. . . ] Warning -- Check if the voltage indicated on the bottom Of the machine corresponds to the local mains voltage before you connect the machine. -- Do not use the machine if the plug, the mains cord or the machine itself is damaged. -- If the mains cord is damaged, you must have it replaced by Philips, a service center authorized by Philips or similarly qualified persons in order to avoid a hazard. -- This machine can be used by children aged from 8 years and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the machine in a safe way and if they understand the hazards involved. [. . . ] -- Follow your country`s rules for the separate collection of electrical and electronic products. correct disposal helps prevent negative consequences For the environment and human health. This chapter summarizes the most common problems you could encounter with the machine. If you are unable to solve the problem with the information below, visit www. Com/support for a list of frequently asked questions or contact the Consumer Care Center in your country. My coffee cup overflows with cold coffee The indicator light flashes slowly. Intensity select: after pressing the coffee button twice, I do not get a stronger coffee. There is not enough water in the water reservoir The float in the water reservoir may be stuck. You have pressed the coffee button twice too fast or you have waited longer than 3 seconds after pressing the button for the first time. If this takes longer than 2 minutes, contact the Philips Consumer Care Center in your country Fill the water reservoir and make sure you place the water reservoir properly into the machine. Empty the water reservoir and shake it a few times to release the float. Clean the water reservoir with hot water and some washing-up liquid or in the dishwasher. Thin-walled cups absorb less heat from the coffee than thick-walled cups. You can preheat the coffee machine and cup by brewing a cup of hot water first without placing a coffee pod in the pod holder. Pressing the coffee button twice to get a stronger coffee is possible within a time frame of 3 seconds. The LED light on the machine will shine less bright if the programming was successful. Always make sure the pod holders are clean and the sieve is not clogged to prevent a vacuum. The coffee machine Perhaps the sieve in The center of the pod If the sieve is clogged, use a washing-up brush to unclog the sieve. If you cannot unclog it properly with the washing-up brush, put the pod holder in the machine and descale the machine according to the instructions. If you press the button twice, you get a smaller cup of stronger coffee. Perhaps a used coffee pod is sticking to the water distribution disk. You may not have used the right number of pods or may have pressed the wrong button. [. . . ] The machine has been Contact the Philips Consumer stored in a room that Care. intensity Select (HD6556 , HD6555 , HD6554) It is possible to brew even shorter stronger cups of coffee by double pressing the 1-cup or 2-cup button. special coffees To brew a special coffee, place a cappuccino pod, a hot chocolate pod or another special coffee pod in the 2-cup pod holder and press the 1-cup button. The descaling procedure consists of two descaling cycles and two flushing cycles. [. . . ]