User manual SEVERIN KA 4820

[. . . ] Risk of electric shock The device is powered by electricity, and so there is always a risk of electric shock. The following precautions are therefore to be taken: Every time the appliance is used, The main body including the power cord as well as any attachment fitted should be checked thoroughly for any defects. Should the appliance, for instance, have been dropped onto a hard surface, or if excessive force has been used to pull the power cord, it must no longer be used: even invisible damage may have adverse effects on the operational safety of the appliance. The appliance should only be connected to a socket installed in accordance with the regulations. [. . . ] Before using for the first time Unpack the appliance completely and remove all packaging materials and stickers. Clean the jug and filter insert as described in the section Cleaning and care. Before making coffee for the first time, let the appliance go through two or three filtration cycles using the indicated maximum amount of cold water, but without using ground coffee. This should also be done if the appliance has not been used for an extended period of time, and after descaling. automatic switch-off To save energy, the appliance (including the hot-plate) will switch itself off automatically about 35 minutes after the brewing cycle is complete. power-cord storage compartment The integrated power-cord storage compartment at the rear is used for storing the power cord. The recess at the bottom facilitates limiting the length of the power cord. making coffee - general information The measuring scales on the water container and glass jug help measuring the correct amount of clean water. Make sure that the indicated maximum amount of water or number of cups is not exceeded. If several consecutive brewing cycles are required, switch off the coffee maker After each cycle and let the appliance cool down for approx. Caution: When filling the appliance with fresh water shortly after a brewing cycle is completed, there is a danger of scalding from hot water or steam escaping through the water outlet. Filling with water: Open the water container and fill it with the desired quantity of water, then close the lid. Preparing the jug: Replace the lid on the jug, and then place it in the appliance. If correctly inserted, the lid will disable the drip-stop mechanism in the filter holder during the brewing cycle. Inserting the paper filter: Open the swing-out filter sideways and insert a size-4 paper filter into the filter holder, first folding down the perforated sides of the filter. Filling with ground coffee: For each regular-sized cup (125ml), a measure of about 6 g (= 1½ - 2 teaspoons) of medium or finely ground coffee will be required. Starting the brewing cycle: Use the button to switch the coffee maker on. Removing the jug: Wait until all the water has passed through; the jug can now be removed. Keeping the coffee warm: The coffee may be kept warm in the jug by leaving it standing on the hot-plate, which remains hot for about 35 minutes after brewing is complete. To interrupt the brewing cycle, or if the keeping-warm function is not needed, use the button to turn the appliance off. Switching off the coffee maker: Once keeping-warm is complete, remove the plug from the wall socket. Models with aroma selection switch: This appliance features a special aroma function, allowing the user to choose coffee with a normal strong flavour, or alternatively a very mild coffee. [. . . ] If the product fails to operate and needs to be returned, pack it carefully, enclosing your name and address and the reason for return. If within the guarantee period, please also provide the guarantee card and proof of purchase. The appliance switches off before brewing is complete; residual water remains inside the container. Check that the jug is properly positioned on the hot-plate, pushing the outlet valve up. [. . . ]