User manual WHIRLPOOL AKG 619/IX

[. . . ] For installation to comply with current safety regulations, an allpole disconnect switch with minimum contact gap of 3 mm must be utilized. The electrical components must not be accessible to the user after installation. Do not touch the appliance with any wet part of the body and do not operate it when barefoot. This appliance is designed solely for use as a domestic appliance for cooking food. [. . . ] Scrap the appliance in accordance with local regulations on waste disposal. Before scrapping, cut off the power cords so that the appliances cannot be connected to the mains. -- For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchased the appliance. iNSTALLATION Unpack the oven and make sure that the oven has not been damaged during transport and that the oven door closes properly. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the oven from its polystyrene foam base at the time of installation. Kitchen units in contact with the oven must be heat resistant (min 90°C). Carry out all cabinet cutting work before fitting the oven in the housing and carefully remove all wood After installation, the bottom of the oven must no longer be accessible. For correct appliance operation, do not obstruct the minimum gap between the worktop and the upper Make sure the power voltage specified on the appliance dataplate is the same as the mains voltage. The dataplate is on the front edge of the oven (visible when the door is open). -- Remove cardboard protection pieces, protective film and adhesive labels from accessories. -- Remove the accessories from the oven and heat it at the MAX temperature for 30 minutes to eliminate The smell and fumes from the insulating materials and protective grease. Do not pour water into the inside of a hot oven; this could damage the enamel coating. Do not drag pots or pans across the bottom of the oven as this could damage the enamel coating. Make sure that the electrical cables of other appliances do not touch hot parts of the oven or become Do not expose the oven to atmospheric agents. The packing material is 100% recyclable and is marked with the recycle symbol . The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal. -- By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. -- The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment. energy saving -- Only pre-heat the oven if specified in the cooking table or your recipe. [. . . ] Use specific oven detergents and follow the manufacturer's instructions to the letter. The oven door can be removed to facilitate B: during prolonged cooking of foods with a high water content (e. ) condensation may form on the inside of the door and around the seal. When the oven is cold, dry the inside of the door with a cloth or sponge. [. . . ]